最近从库里领来一个CP343-1,型号为6GK7 343-1EX30-0XE0,V2.3,包装里附带升级光盘,我将光盘里的更新全部安装后,发现硬件组态里只有V2.0的,MAC地址和IP设置完成后,保存编译,出现如下提示:
save and compile(4502:632)
module (CP343-1):System error SDB
generation:error in rule file or rule file not found. 确定后,又出现如下提示: save and compile(13:76)
(3117)ERROR while creating the system data.
Do you want to continue? 以下是帮助文件: Help on Message 13:76
Des cription:
While creating the system data blocks (SDB) for the module which is the SDB receiver, an error was recognized in the programming device and processing halted.
The number of the SDB type which could not be created is shown in brackets ().
Cause:
?Inconsistent hardware configuration in the programming device.
?Missing or read-only folder "...\SIEMENS\STEP7\S7TMP" or "...\SIEMENS\SIMATIC_NCM\S7TMP".
?Missing authorization for an optional package that creates SDBs for a particular module.
Remedy:
You can decide whether to continue or abort processing.
In either case you must remember that the hardware configuration downloaded to the module or the hardware configuration saved may be incomplete or inconsistent.
We recommend the following procedure:
1. Abort processing.
2. Correct the cause of the error:
?Correct the hardware configuration.
?Remove the write-protection from the "...\SIEMENS\STEP7\S7TMP" folder or create the folder.
?Install the missing authorization.
3. Select the function again.
See also:
You can find further information and FAQs here on the internet...
请问:1.如何纠正硬件配置?2.如何除去 "...\SIEMENS\STEP7\S7TMP"文件夹的写保护?3.如何安装丢失的授权?(我个人感觉应该是授权之类的文件没有被正确安装....)亦或者有其他什么办法解决?请您具体解答,小生不胜感激!