我的系统是315-2dp+cp343-1 ，下边挂的是200PLC 。今天做程序的时候，因为几套系统都一样，所以就把一套做好了后就复制了程序的所有块。PLC里边有程序，结果下载后都报错了。再编译硬件组态的时候就CP343-1就报错：(3100 for module rack: 0, slot: 4) Error creating the
system data. Do you want to continue?看了下不知道怎么处理，新建一个项目再重新组态的时候也是一样，如果343-1不激活网络的话就不会报错。帮帮忙看下是什么问题了 ，急需解决这个问题。谢谢。 查看帮助时这样说的：Des cription of Error:

Error attempting to generate the configuration data.
Possible causes:

· Hard disk full

· No "...SIEMENS\STEP7\S7TMP" folder available or the folder is read-only

· "S7 Program" or "M7 Program" folder missing

· The block folder is currently being edited

· Compiling (creating the configuration data) was interrupted

To Correct or Avoid Error:

· Delete any files not required from the hard disk

· Remove the write-protection from the "...SIEMENS\STEP7\S7TMP" folder or create the folder again

· Recreate the "S7 Program" or "M7 Program" folder

· Stop editing of the block folder

· Reinstall STEP 7