Switching the coupling ON/OFF

CC_COPON()
CC_COPON([A1][A2][A3][A4][A5])
Switching the 1:1 coupling. Monitoring of tolerance window is active.

CC_COPONM()
CC_COPONM([A1][A2][A3][A4][A5])
Switching the 1:-1 coupling (mirror). Monitoring of tolerance window is not active.
A1 to A5 are axis names. These can be used to program either the machine axis names,
channel axis names or geometry axis names of the axis assigned to a coupling. In other
words, either the CC_Master axes or the CC_Slave axes or both can be programmed at the
same time. An alarm is output if an axis not involved in a coupling is programmed in A1-A5.
All defined couplings are switched on with CC_COPON() or CC_COPONM(). An active
coupling is displayed via the CC_Slave axis in axial VDI-Out byte:
DB31, … DBX97.1 (activate coupling)
If mirroring is active, it is displayed additionally in:
DB31, … DBX97.2 (activate mirroring)
A coupling can be disabled via the CC_Slave axis in axial VDI-Out byte:
DB31, … DBX24.2 (disable CC_Slave axis coupling)
This does not generate an alarm.

CC_COPOFF()
CC_COPOFF([A1][A2][A3][A4][A5])
As CC_COPON or CC_COPONM() except for the fact that no alarm is generated if A1 to A5
is used to program an axis that is not involved in a coupling.
An existing coupling can also be switched off via the axial VDI-In bit on the CC-Slave axis.
The coupling can be switched ON or OFF only if all axes involved are stationary.