63,64,48,663都有信号

NC中也设置了
以下的PLC位也设置了
NST “Controller enable” (DB31–61, DBX2.1)
NST “Pulse enable” (DB31–61, DBX21.7)
NST “Position measuring system 1 or 2” (DB31–61, DBX1.5, DBX 1.6)
The following signals on the interface must not be set or else the axis/spindle
motion will be disabled:
NST “Feed/spindle correction switch” (DB31–61, DBB0) not set to 0%
NST “Axis/spindle disable” (DB31–61, DBX1.3)
NST “Adjustment mode” (DB31–61, DBX1.4)
NST “Remaining distance/spindle reset” (DB31–61, DBX2.2)
NST “Feed stop/ spindle stop” (DB31–61, DBX4.3)
NST “Travel button disable” (DB31–61, DBX4.4)
NST “Power-up sensor disable” (DB31–61, DBX20.1)

电机已经能锁死，为啥不能点动呢？