我们有台进口设备，PLC：CPU315 DP，PROFIBUS有四驱动器：一台CUVC+CBP2（6SE7090-0XX84-0FF5）+T400 一台CUVC+CBP2，两台为MM4 通讯板为：6SE7090-0XX84-2FB0，但下载组态一半时显示（2000)error while uploading the configuation to the programming device (PG),DO YOU WANT TO CONTINUE?
帮助显示为Des cription of Error:

While interpreting the system data blocks (SDBs) uploaded from the module, an error was recognized in the programming device and processing halted.

Cause:

?Inconsistent hardware configuration in the module
(occurs if downloading the SDBs to the module was already incomplete or inconsistent)

?The optional package for configuring certain modules (for example, CPs) is not installed

?The module was configured with a later version or STEP 7, and the current version of STEP 7 cannot interpret the SDBs.

To Correct or Avoid Error:

You can decide whether to continue or abort processing.
Ensure that all software packages required for configuring the station are installed on your programming device.
Ensure that you have a STEP 7 version that can be used to configured all modules.

In either case you must remember that the hardware configuration uploaded to the programming device may be incomplete or inconsistent.

See also:

You can find further information and FAQs here on the internet...

这时可以下载程序，但不能下载组态
我用的是S7-MANNGER V5。3，GSD文件也不缺，CBP2等通讯模块是标准配置
为什么？是否要安装DRIVE ES？