我的程序在PLCSIM下运行正常.现在我想把程序下载到CPU中,因为我的程序有660K,而414H(v4.0)的装载内存只有256K,我尝试把程序写到FLASH卡然后运行,但是CPU会停机,不知道如何解决此问题?
附件为停机时的诊断信息,各位大虾帮忙分析一下,看原因何在?
另:我问过SIEMENS的技术支持,他说是卡里多次写程序引起程序不完整所致;但是我在PG里重新擦除后再写,问题依旧!
Event 1 of 120: Event ID 16# 530D
New startup information in STOP mode
Startup prevented by:
User program invalid
- STOP request exists
- Cold restart or warm restart necessary
Startup information:
- Time for time stamp at the last backed up power on
- Single processor operation
Current/last startup type:
- No startup type/following memory reset
Permissibility of certain startup types:
- Manual startup not permitted, corrections in parameter assignment, submodule, etc. necessary
Last valid operation or setting of automatic startup type at power on:
- No startup type/following memory reset
Operating mode: STOP (internal)
Event occurred in the master CPU in rack 0
Incoming event
08:57:45:497 am 08/10/06
Event 5 of 120: Event ID 16# 4542
STOP caused by object management system
Previous operating mode: STOP (internal)
Requested operating mode: STOP (internal)
Event occurred in the master CPU in rack 0
Internal error, Incoming event
08:36:53:506 am 08/10/06
Event 9 of 120: Event ID 16# 494F
STOP caused by configuration error
Error type: CPU number already assigned to another CPU
Previous operating mode: STOP (internal)
Requested operating mode: STOP (internal)
Event occurred in the master CPU in rack 0
External error, Incoming event
08:36:52:672 am 08/10/06