在S7组态下下去以后CP343-1显示STOP,但是与S7的通讯能连上.组态编译的时候出现"An error occurred creating or interpreting the system SDB. The action be aborted".
硬件在线诊断为:
Diagnostic buffer of module CP 343-1

Order No./ Des cription Component Version
6GK7 343-1EX21-0XE0 Hardware 1
- - - Firmware V 1.1.13
Boot Rom Firmware expansion V 1.72.0

Rack: 0
Slot: 4


Event 1 of 7: Event ID 16# F9C1:0220
I/O enable by S7 CPU
External error, Incoming event
12:07:47.965 AM 01/01/1994


Event 2 of 7: Event ID 16# F9C1:0266
Module STOP due to modification of the database.
External error, Incoming event
12:07:27.313 AM 01/01/1994


Event 3 of 7: Event ID 16# F9C1:0254
Netinterface: Automatic setting, TP/ITP with 100 Mbps full duplex
External error, Incoming event
12:07:26.355 AM 01/01/1994


Event 4 of 7: Event ID 16# F9C1:0261
The MAC address was fetched from the boot EPROM. This is the factory setting.
External error, Incoming event
12:07:26.256 AM 01/01/1994


Event 5 of 7: Event ID 16# F9C1:0203
Module database invalid.
Internal cause: 8702
External error, Incoming event
12:07:24.875 AM 01/01/1994


Event 6 of 7: Event ID 16# F9C1:0264
Module restart.
External error, Incoming event
12:00:11.378 AM 01/01/1994


Event 7 of 7: Event ID 16# F9C1:020D
Hardware reset on P bus
External error, Incoming event
12:00:11.058 AM 01/01/1994


怎么回出现这情况呢??怎么解决??谢谢