9. Set P–097 to 1H ”SEtUP” is displayed
10. Wait until the operating display P–000 appears
11.IS a special motor used，where there is no code number definded for P-096? 确认是不是西门子专用电机。
1)Yes: enter p-159---p-176。输入159到176的参数 。
set p-177 to 1 (calculate motor data) wait until p-177 is again set to 0H （可能不用这步）
Set P–051 to 4H Set P–052 to 1H
Wait until P–052 is again set to 0H (write into FEPROM)接12
2)No 接 12
12. Check, and if required, change the following parameters:
P–014 normalization nset
P–015 offset correction nset
P–024 normalization nset
P–016 ramp–up time, ramp–fct. generator 1
P–017 ramp–down time, ramp–fct. generator 1
P–029 maximum motor speed nmaxmot
P–021 to P–023, relay response values of the
P–027 speed monitoring
P–039 to P–043 torque limits
P–047to p050
P–057 to P–058 open–controlled range
P–059 to P–060 limits
P–081 to P–089 freely–programmable
terminal functions
P–113 to P–114 speed setpoints
P–185 to P–194, freely–programmable
P–241 to P–246 Relay functions
13.值改过Set P–052 to 1H
Wait until P–052 is again set to 0H (write into FEPROM)
14. Check all parameterized functions and if required change
值改过Set P–052 to 1H
Wait until P–052 is again set to 0H (write into FEPROM)
15.Set P–051 to 0H.Set write protection